IS 1852 Rolling and cutting tolerances for hot rolled steel products
CurrentLatest edition found. Still confirm amendments with the publisher.
- Edition
- IS 1852:1985 (Fourth Revision)
- Publisher
- IS
- Part family
- Steel grades & sections
- Reviewed
- 27 October 2026 · source checked
Is IS 1852 still current?
Yes. IS 1852:1985 (Fourth Revision) is the latest edition MechAtlas found (MechAtlas review: 27 October 2026). Check the publisher for amendments before you specify it.
What it covers
Rolling and cutting tolerances for Indian hot rolled steel products.
Parts that use IS 1852
- Steel plate (India (IS), related)
Flat hot-rolled steel 3 mm and thicker, used for base plates, gussets, liners, chutes and fabricated parts.
Rolling and cutting tolerances.
Official source
MechAtlas does not reproduce standards. Check the official edition at the publisher's page for IS 1852 or the IS store.
Open in MechAtlasCheck a drawing callout
Other steel grades & sections standards
- EN 10277 Replaced
Bright steel products - IS 2062 Replaced
Hot-rolled structural steel - DIN 1025-2 Withdrawn
Wide flange I-beams (IPB / HEB series) - IS 12778 Withdrawn
Parallel flange beams, columns and bearing piles - EN 10210-1 / 10219-1 Changing
Hot-finished / cold-formed hollow sections - ASTM A105/A105M Current
Carbon steel piping forgings - ASTM A108 Current
Cold-finished carbon and alloy steel bars - ASTM A1085 Current
Cold-formed welded carbon steel HSS - ASTM A240/A240M Current
Stainless plate, sheet & strip - ASTM A29 Current
General requirements for hot-wrought steel bars - ASTM A36/A36M Current
Carbon structural steel - ASTM A572 / A992 / A500 / A514 Current
HSLA, W-shapes, HSS, Q&T plate